Audi 3.0T Tech Guides & News

ÜberBrick Redesign Update: What We Found, and Where Things Stand

If you placed a pre-order for the ÜberBrick intercooler and have been waiting on an update, this is it.

What Rev.1 and Batch Rev.1 mean

Rev.1 is our name for the original ÜberBrick design: the bar-and-plate core we built and tested, and the one that performed like the OEM brick. Batch Rev.1 is what the manufacturer actually produced for that production run. It used a different fin than we specified, and we found out only after testing a unit from that batch.

We're not shipping Batch Rev.1 to anyone. This update is about what we found, and what we're doing about it.

What we found in testing

In testing, Batch Rev.1's intake air reached 176°F (80°C), the point where the ECU pulls timing to protect the engine. That's a measured result, not a simulation: direct evidence that the fin inside that batch could not move enough heat into the coolant. A weaker intercooler than stock defeats the entire purpose of this product, so we stopped the production run rather than ship it.

Where we are now

We're redesigning the core from the ground up and vetting manufacturers on exact, written specifications rather than taking a sample on faith. The table below shows where that stands today, measured the same way for every entry: predicted intake air temperature at a hard pull, 24 psi, 80°F ambient. Lower is better.

Design Status Predicted intake air
Redesign candidate (tooled to target) Proposed, not yet confirmed 137.6°F (58.7°C)
Redesign candidate Confirmed in writing 139.4°F (59.6°C)
Redesign candidate Confirmed in writing 142.8°F (61.5°C)
Rev.1 — our original design Built and tested 148.2°F (64.5°C)
Factory-style brick — for reference Modeled baseline 152.3°F (66.8°C)
One manufacturer's standard part Confirmed, not selected 161.2°F (71.8°C)
Batch Rev.1 — what the factory built Tested, hit the ECU cutoff 176.0°F (80.0°C)

Every confirmed redesign candidate on this list already beats both Rev.1 and the factory-style baseline. Manufacturer names are withheld while we finalize terms.

What happens next

We're finishing manufacturer vetting, confirming pricing and lead times in writing, and will post here again as the redesign firms up. If you have a pre-order in, you don't need to do anything — we'll reach out directly before anything ships.

Drive the difference. Drive Vorsprung.

Previous
Audi A6 3.0T Upgrades: The Right Mod Order for the Supercharged C7 and C7.5 A6 and A7 (2012 to 2018)
Next
Audi B9 S4 Intercooler Upgrade: Beat Heat Soak, Pick the Right Core and Install It Right (B9 and B9.5 S4, S5)

Parts for this job